Dear Members, To protect the forum from spam, all new members initial posts will require approval before they are published. Please do not create a duplicate thread. If you do not see the thread then it has been queued for review.  If in any doubt, please contact us through DM Regards Decawave

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
About Timestamp
#1
I am currently working on Wired sync TDoA-Positioning. 
I'm trying the external clock and the sync. The external clock seems working ok.
Tag transmit a blink message, periodically.
And Anchor receive the blink message very well.
But, I have a problem
After reading data register(dwt_readrxdata),
checking rx time stamp register(dwt_readrxtimestamp)
The value is always '0'.
please advice check point to me.

Thank you
Best regards,
GyuKang
Reply
#2
Regarding the zero’s
Would you have loaded the LDE during initialisation? Ie did you use dwt_initialise(DWT_LOADNONE) instead of dwt_initialise(DWT_LOADUCODE).
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)